Maintenance of ball turntable bearings

It is good practise to carry out periodic controls of the lubrication of the turntable bearing.
The frequency of greasing must be programmed according to working conditions, on average once a month. The operation of pumping new grease should be carried out until the grease leaks out of the fissure between the two rings.
During the greasing operation, allow the turntable bearing to rotate.
Lithium grease designated with the marking EP2 or 2 by the leading manufacturers, may be used.
For bolts, we advise that you carry out controls, once a month and depending on use, on the tightening force of the screws, according to the values indicated in the table.